Aeromotive 17143 - 96-98 1_2 4.6L DOHC COBRA A1000 FUEL SYSTE Manuel d'utilisateur télécharger pdf

AEROMOTIVE

Part # 17143 & 17144

96-98 1/2 4.6L DOHC Return Style Fuel System Kit

INSTALLATION INSTRUCTIONS

CAUTION:

Installation of this product requires detailed knowledge of automotive systems and

repair procedures. We recommend that this installation be carried out by a qualified

automotive technician.

Installation of this product requires handling of gasoline. Ensure you are working in a

well ventilated area with an approved fire extinguisher nearby. Extinguish all open flames,

prohibit smoking and eliminate all sources of ignition in the area of the vehicle before

proceeding with the installation.

When installing this product, wear eye goggles and other safety apparel as needed to

protect yourself from debris and sprayed gasoline.

WARNING!

The fuel system is under pressure. Do not open the fuel system until the pressure has

been relieved. Refer to the appropriate vehicle service manual for the procedure and

precautions for relieving the fuel system pressure.

Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.

This kit assumes you have a sumped fuel tank or fuel cell with provisions for a gravity feed AN-10 supply line and

AN-06 return line.

This kit contains the following parts

1 ea fuel pump wiring kit

1 ea 3ft length of 10 ga. Black wire

1 ea 25ft length of 10 ga. Red wire

1 ea 30 amp circuit breaker

1 ea 30 amp automotive relay

2 ea blue female blade connector

2 ea yellow female blade connector

5 ea yellow #10 stud ring connector

1 ea yellow 3/8” stud ring connector

6 ea tie-wraps

4 ft AN-10 stainless steel braided line

16 ft AN-06 stainless steel braided line

26 ft AN-08 stainless steel braided line

2 ea AN-10 90-degree hose end

2 ea AN-08 straight hose end

6 ea AN-08 90-degree hose end

2 ea AN-08 Male 90-degree hose end

1 ea AN-06 straight hose end

1 ea AN-06 90-degree hose end

1 ea p/n 11101 Pump (17143 Kit only)

1 ea p/n 11104 Pump (17144 Kit only)

1 ea p/n 12304 Filter 100 Micron SS

1 ea p/n 12301 Filter 10 Micron Paper

1 ea p/n 13101 Fuel Pressure Regulator

1 ea p/n 14104 Ford 4.6L DOHC Fuel Rails

1 ea Y-block Assembly

2 ea p/n 15607 AN-08 cutoff union

2 ea AN-08 o-ring

1 ea p/n 15610 AN-10 cutoff to AN-08 union

1 ea AN-10 o-ring

4 ea ¼” flat washers

4 ea ¼-20 nyloc nuts

4 ea ¼-20 x 1” carriage bolts

12 ea tie-wraps

1 ea AN-06 o-ring

4 ea AN-08 o-ring

8 ea AN-10 o-ring (17143 kit only)

7 ea AN-10 o-ring (17144 kit only)

1 ea AN-12 o-ring (17144 kit only)

1 ea p/n 15606 AN-06 cutoff union

2 ea p/n 15607 AN-08 cutoff union

3 ea p/n 15608 AN-10 cutoff union (17143 kit only)

2 ea p/n 15608 AN-10 cutoff union (17144 kit only)

3 ea p/n 15610 AN-10 cutoff to AN-08 union

1 ea p/n 15613

AN-12 cutoff to AN-10 union (17144 kit only)

1 2 3 4 5 6 ... 14 15

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

AEROMOTIVE Part # 17143 & 17144 96-98 1/2 4.6L DOHC Return Style Fuel System Kit INSTALLATION INSTRUCTIONS CAUTION: Installation of this prod

Page 2

Section 4 - Fuel Line Hose End Installation: CAUTION: When assembling this product, wear eye goggles and other safety apparel as needed to protect y

Page 3

4-7. Using a properly sized wrench, complete threading the two components together (The maximum allowable gap between the two fitting components is

Page 4

Section 5 - Electrical Installation: 5-1. Find a suitable place to mount the supplied relay, the relay is typically mounted by the OEM fuel pump wir

Page 5

Thanks for purchasing another quality product designed, engineered and manufactured in Kansas City, USA! AEROMOTIVE, INC. 7805 Barton Street, Lenexa,

Page 6

Page 7

Aeromotive, Inc. 7805 Barton Street, Lenexa, KS 66214 Phone: (913) 647-7300 Fax: (913) 647-7207 AEROMOTIVE, INC. LIMITED WARRANTY This Aeromotive

Page 8

Warning – The included Aeromotive fuel pump is not compatible with alcohol based fuels or fuel additives! The following steps are typical of most i

Page 9

Section 1 - Fuel Pump Installation: 1-1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel syste

Page 10 - CAUTION:

1-9. Install one of the supplied AN-10 o-rings on the cutoff side of the AN-10 cutoff union fitting, if not already installed, and install on the inl

Page 11

1-17. Using the above steel braided hose assembly, connect one end to the outlet of the fuel tank sump and the other end to the fuel pump / filter a

Page 12

Section 2 – Fuel Rail Installation 2-1. Check for any dirt or debris around the fuel injectors. If any is evident, wash it off with some solvent pa

Page 13 - AEROMOTIVE, INC

Section 3 – Fuel Regulator Installation and Fuel Line Plumbing 3-1. In the vehicle’s engine compartment, mount the supplied fuel pressure regulator

Page 14

3-7. Install two of the supplied AN-08 o-rings on the two supplied AN-08 90-degree Male Hose ends. 3-8. Using the above two AN-08 90-degree male

Page 15

3-13. Starting from the fuel rails, plan a route to run an AN-08 supply line from each fuel rail to each side of the Y-block. Cut the two supply li

Commentaires sur ces manuels

Pas de commentaire

Aeromotive 17143 - 96-98 1_2 4.6L DOHC COBRA A1000 FUEL SYSTE Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Aeromotive 17143 - 96-98 1_2 4.6L DOHC COBRA A1000 FUEL SYSTE. Aeromotive 17143 - 96-98 1_2 4.6L DOHC COBRA A1000 FUEL SYSTEM User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Aeromotive 17143 - 96-98 1_2 4.6L DOHC COBRA A1000 FUEL SYSTE