Aeromotive 13211 - MARINE CARBURETED ADJUSTABLE REGULATOR, OR Manuel d'utilisateur télécharger pdf

AEROMOTIVE

Part # 13201

INSTALLATION INSTRUCTIONS

CAUTION:

Installation of this product requires detailed knowledge of automotive systems and

repair procedures. We recommend that this installation be carried out by a qualified automotive

technician.

Installation of this product requires handling of gasoline. Ensure you are working in a

well ventilated area with an approved fire extinguisher nearby. Extinguish all open flames,

prohibit smoking and eliminate all sources of ignition in the area of the vehicle before

proceeding with the installation.

When installing this product, wear eye goggles and other safety apparel as needed to

protect yourself from debris and sprayed gasoline.

WARNING!

The fuel system may be under pressure. Do not open the fuel system until any pressure

has been relieved. Refer to the appropriate vehicle service manual for the procedure and

precautions for relieving the fuel system pressure.

The enclosed Aeromotive regulator utilizes one o-ring sealed AN-06 style inlet port located at

the base of the regulator and two o-ring sealed AN-6 style outlet ports located on the sides of

the regulator; these regulator ports are NOT PIPE THREAD

and utilize NO THREAD SEALANT.

Performance Specifications: Model 13201

Outlet Fuel Pressure, adjustable 5-12 psi

Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.

The following steps are typical of most installations:

1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the

fuel system pressure.

2. Place shop towels around the existing regulator to catch any gasoline that is spilled during this step

of the installation. Remove any regulator mounting hardware and connecting fuel lines, then

carefully remove the regulator.

3. Find a suitable place in the vehicle’s engine compartment to mount the Aeromotive regulator. Using

the supplied mounting bracket as a template, mark the bracket mounting holes and drill to accept a

#10 screw.

4. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two

#10 screws, nuts and lock washers.

5. Attach the fuel supply line(s) to the regulator inlet (located at the base of the regulator) using AN-06

style fittings and o-rings.

1 2 3

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

AEROMOTIVE Part # 13201 INSTALLATION INSTRUCTIONS CAUTION: Installation of this product requires detailed knowledge of automotive systems and repair

Page 2 - AEROMOTIVE, INC

6. Attach the fuel supply line(s) to the carburetor(s) using AN-06 style fittings and o-rings. Install AN-06 style plugs and o-rings into the regulat

Page 3

Aeromotive, Inc. 7805 Barton Street, Lenexa, KS 66214 Phone: (913) 647-7300 Fax: (913) 647-7207 AEROMOTIVE, INC. LIMITED WARRANTY This Aeromotive

Commentaires sur ces manuels

Pas de commentaire

Aeromotive 13211 - MARINE CARBURETED ADJUSTABLE REGULATOR, OR Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement pour l'eau Aeromotive 13211 - MARINE CARBURETED ADJUSTABLE REGULATOR, OR. Aeromotive 13211 - MARINE CARBURETED ADJUSTABLE REGULATOR, ORB-06 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement pour l'eau Aeromotive 13211 - MARINE CARBURETED ADJUSTABLE REGULATOR, OR